Goedehoop Mine Ventilation Shaft

Image of Goedehoop Mine Ventilation Shaft
Client Anglo American Coal Site Goedehoop Mine Scope Concrete Waterproofing, Rejuvenation and Crack Repair Where Witbank, Mpumalanga

Background

South Africa has a long history when it comes to mining. It is an industry that forms the backbone of the South African economy and Anglo American have been a key catalyst to help create a stronger, safer , healthier, and more sustainable South Africa since 1917.

One of the key requirements in mining is to ensure adequate ventilation of a mine, provisions are made for suitable airways for the air to flow down the mine to the working areas. The primary ventilation system consists of an intake (downcasts) through which the fresh air passes to the mine workings, and an exhaust (or upcasts) where the air passes after having been ventilated. Any interference with the ventilation system would have an impact on operations and safety.

The Goedehoop Colliery Block 7 mine ventilation downcast shaft is approximately 60m deep and was constructed in the 1980’s. The shaft consists of a segmented ring liner arrangement with an interlocking joint connection between the different shaft segments. The shaft had experienced the ingress of water over the last 35 years with a notable increase in the last couple of years through the joint interface, posing potential flooding and deterioration to the existing concrete shaft liner.

The excessive leaks were being pumped out on a daily basis as part of a routine operation which was required for the normal running of the mine.

Over the years the underground water levels increased exacerbating the potential for significant leakages and flooding of the mining levels.

Early in 2017, the underground build-up of water broke through the concrete ventilation shaft, allowing excessive water penetration into the mine.

A solution to the excessive water penetration into the shaft (approximately 7000 litres per minute) was required, failing which the possibility of closing the affected shafts was inevitable.

The ingress pressure of the water was immense, shooting water torrents approximately 300mm wide across the 7m diameter shaft.

There were numerous water ingress points along the full depth of the shaft, with the primary water ingress area, located between 19 and 25 m below ground level.

Being a ventilation shaft, there was no access to these areas, which therefore required the manufacture and installation of elaborate custom-made access equipment for both personnel and equipment which was undertaken by Sky Jacks.

A solution to the ingress of water from the positive to negative path (from outside the shaft into the shaft opening) was required. In addition, there was no access to the positive side - being underground.

Semane Consulting Engineers, who specialise in mining infrastructure and are solution driven, contacted Sanika Waterproofing Specialists contractors with whom they had previous successful dealings at Impala Platinum Limited to undertake the specialized and complex remedial measures to initially abate and eventually eliminate the ingress of water into the shaft.

Semane Consulting Engineers as well as the access specialists, Sky Jacks, were actively involved throughout the project.

Even after extensive panel tests by various contractors, none were able to apply a product that could withstand the immense negative pressure exerted by the water in the mine shaft.

After an in-depth site evaluation, it was noted that the mine was under approximately 20 meters of water and the repair of a water penetration point at this level posed many difficulties and risks.

Numerous tests were carried out to ascertain the best procedures to access the mine, to investigate the concrete damage below water level, to confirm structural integrity as well as safety.

The scope of work focused on the main water ingress points which were in urgent need of concrete repair and jointing detail as well as surface waterproofing applications.

Solution

Sanika Waterproofing Specialists found it to be critical that the entire structure be correctly rejuvenated, repaired and waterproofed using Kryton Crystalline Technology, which has a proven success record in similar case studies worldwide for the past 40 years.

The very first obstacle to overcome was that of access down the 7m diameter shaft riddled with leaks. After numerous discussions and on-site tests, Sky Jacks, the appointed access company, devised a cradle system to safely lower workers into the shaft. The cradle also needed to be stabilised against the sides of the shaft to reduce movement for the work at hand. The inspection and preparation of the site was imperative for this project. A borehole had to be sunk to the depth of the major water ingress and camera equipment sunk into the borehole to accurately investigate the ingress from the positive side. A scan of the concrete in the affected areas by GPRS equipment was conducted to ensure the safety and integrity of the structure was still intact.

With information gathered by visuals, a Krytonite™ Swelling Waterstop had to be introduced to the positive side to reduce the water flow to a manageable condition.

Based on all information gathered during the investigation stage, Sanika Waterproofing Specialists concluded that the Kryton Leak Repair System was the best course of action for a project of this magnitude.

In order to prepare the site for the application of Kryton products, the damaged sections of concrete had to be cleaned and prepared using a dustless sandblasting and ultra-high pressure cleaning. Concrete cutting machines and chisels were used to chip chases along the entire length of all water ingress points, construction joints and cracks.

Running water was stopping by the use of Kryton’s Krystol Plug and Kryton’s Krytonite™ Swelling Waterstop that expands up to 1000% on contact with water.

Chased cold joints were filled with Kryton Krystol Repair Grout (specially mixed dry-mix). Kryton’s Krystol T1 and T2 waterproofing compounds were applied to the surface in a slurry form in accordance with manufacturer’s specification.

The Kryton Krystol ™ application over the entire surface of the concrete structure resulted in the growth of crystals throughout the concrete mass preventing any further water or air ingress into the concrete, thus transforming the concrete itself into a waterproof barrier.

The growth of these crystals into the concrete and subsequent waterproofing of the concrete will retard any further deterioration of the concrete structure from water ingress and will therefore substantially lengthen the lifespan of this structure.

The overall result is a safe, dry and useable structure

Sanika Waterproofing Specialists are the approved exclusive distributors and applicators of Kryton products in Southern Africa.

1. View from top of shaft showing the major water penetration 1024x768
2. Access installed by Sky Jacks
4. Major water penetration1 768x1024 1024x768
5. Major Water penetration through holes in the shaft wall 360x480 1024x768
8. Major water ingress contained to a single point using Kryton plug
11. Surface view of applied Kryton T1 and T2
14. First time standing on a dry area in 35 years
16. View from bottom of shaft once project was complete

Products used

Krystol Bari-Cote™

Krystol Bari-Cote is a high-strength crystalline concrete waterproofing top coat used to resurface and repair concrete or masonry.

Krytonite™ Swelling Waterstop

Krytonite Swelling Waterstop is a synthetic rubber waterstop that uses swelling pressure to completely seal concrete construction joints.

Krystol® Leak Repair System

The Krystol Leak Repair System is a permanent crystalline waterproofing solution used for repairing leaking cracks, holes and joints found in concrete

Krystol T1® Concrete Waterproofing

Kryton Krystol T1 is a surface-applied crystalline slurry treatment that transforms new or existing concrete into a permanent waterproof barrier.

Krystol Plug™

Krystol Plug is a rapid-setting hydraulic cement product that when mixed with water is used to stop flowing water and repair leaking cracks, holes and joints in concrete.

Contact Us Today
+27 (011) 425 3061 7 Hills Street, Rynfield
Benoni, 1501
South Africa

Company Reg: 1992/009387/23